Metrohm tiamo 2.4 (process analysis) - Manual (Page 1202)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1186 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
[Properties]
Opens the dialog window External measured value # in which the
parameters for the external measured value can be edited (see Chapter
5.6.3.11.2, page 934).
[Delete]
Deletes the external measured value selected in the table.
5.6.6.3.5 DOS U
5.6.6.3.5.1 DOS U - Overview
Dialog window: Method ▶ DOS U ▶ Properties... ▶ DOS U - 'Command name'
Command for controlled dosing with measured value U.
Devices
This command can be executed with the following devices:
Titrando: 835, 836, 842, 857, 902, 906, 907
Titrino: 718, 736, 751, 799
pH/Ion Meter: 867
Robotic Titrosampler: 855
Appearance
The command has the following appearance:
Parameters
The parameters for the command DOS U are configured in the following
5 tabs:
￭ General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
￭ Dosing parameters
Parameters for the dosing settings.
￭ Stop conditions
Definition of conditions which cause the stop of the dosing.
￭ Monitoring
Definition of measured value and temperature monitoring.
￭ Additional measured values
Definition of additional measured values of other measuring com-
mands which are saved as additional columns in the measuring point
list.