Metrohm tiamo 2.4 (process analysis) User Manual
Page 64
2.4 Formula editor
■■■■■■■■■■■■■■■■■■■■■■
48
■■■■■■■■
tiamo 2.4 (for Process Analysis)
Identifica-
tion
Description
Commands
.MI.VOL
Volume at minimum measured
value in mL
DET, MET, SET,
KFT, STAT
.MN.MEA
Average of the measured value in
the unit of the measured value
MEAS T/Flow
.MR.MRC
Correlation coefficient for mean
dosing rate for the whole range
STAT, DOS
.MR.MRS
Standard deviation for mean dos-
ing rate for the whole range in
mL/min
STAT, DOS
.MR.MRT
Mean dosing rate for the whole
range in mL/min.
STAT, DOS
.MTE
Temperature measurement with
sensor; 1 = on, 0 = off)
DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without T/Flow,
Ref, Spec), CAL
Cond, CAL
MEAS, STDADD,
DOS, ELT MEAS
.NMP
Number of measuring points in
measuring point list
DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec), CAL Cond,
CAL MEAS, DOS,
ELT MEAS
.OVE
Value of the output at the end of
the command.
Direct controller/2-point control-
ler: 1 = active, 0 = inactive
PID/PWM: -100 to 100% (value of
the analog output or the pulse
frequency)
CONTROL