Metrohm tiamo 2.4 (process analysis) User Manual
Page 1632
7.19 Balances
■■■■■■■■■■■■■■■■■■■■■■
1616
■■■■■■■■
tiamo 2.4 (for Process Analysis)
Selection
None | Odd | Even
Default value
None
Stop bit
Number of stop bits.
Selection
1 | 2
Default value
1
Handshake
Type of data transmission protocol.
Selection
None | HW | SW
Default value
None
Timeout
Maximum waiting time for receiving characters. If this time is exceeded,
receiving will be stopped.
Input range
1000 - 9999 ms
Default value
2000 ms
Terminator for send
Terminator for send in hexadecimal code.
Selection
\0D | \0D\0A | \0D\0A\0A | \0D\0D\0A
Default value
\0D\0A
(\0D = CR, \0A = LF)
Terminator for receiving
Final character for receiving in hexadecimal code.
Selection
\0D | \0D\0A | \0D\0A\0A | \0D\0D\0A
Default value
\0D\0A
(\0D = CR, \0A = LF)
Code page
Code page used for the data transfer.
Selection
Cp437 | Cp850 | Cp852 | ASCII
Default value
Cp437
[Connect]
Establishes the connection to the balance. The dialog window Establish
connection appears (see Chapter 7.19.5, page 1618).
[Disconnect]
Disconnects the connection to the balance (only then the device can be
deleted out of the configuration).