Metrohm tiamo 2.4 (process analysis) - Manual (Page 55)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
2 General program functions
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 39
Identifica-
tion Description Commands
.BSY Command status; 1 = BUSY,
HOLD or ERROR; 0 = READY;
invalid (variable not available) =
Command has never been started All except START
and END
.C0 Coefficient c0 of the calibration
curve CAL Spec, CAL
LOOP Opt
.C1 Coefficient c1 of the calibration
curve CAL Spec, CAL
LOOP Opt
.C2 Coefficient c2 of the calibration
curve CAL Spec, CAL
LOOP Opt
.C3 Coefficient c3 of the calibration
curve CAL Spec, CAL
LOOP Opt
.CAL Status of the calibration: 1 = cali-
brated normally, 0 = can-
celed, because reference wave-
length was not found. CAL Spec
.CBY Command status; 1 = Condi-
tioning activated, 0 = Condi-
tioning deactivated SET, KFT, KFC,
BRC
.CLC Cell constant of the sensor used
in the command (with conductiv-
ity sensors) MET Cond, MEAS
Cond, CAL Cond
.COD Coefficient of determination (R 2 ),
which is calculated on the basis of
the calibration function and of
the confidence interval.
CAL LOOP Opt
.COK Command status; 1 = Condition
requirement fulfilled, 0 = Con-
dition requirement not ful-
filled SET, KFT, KFC,
BRC
.CONC Concentration of the solution
used for the command DET, MET, SET,
KFT, STAT, ADD,
DOS, LQH,
STDADD