Metrohm tiamo 2.4 (process analysis) - Manual (Page 1466)

6.8 Subwindow Colorimetric sensors
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1450 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
The colorimetric sensors can be selected in the Methods part with the var-
ious commands. The colorimetric sensors appear in alphabetical order, but
only in descending sequence, in the list field Colorimetric Sensor, on
the tab General/Hardware.
6.8.2.4 Deleting a colorimetric sensor
Menu item: Configuration ▶ Colorimetric sensors ▶ Edit ▶ Delete
With Edit ▶ Delete, the colorimetric sensor selected in the sensor table is
deleted.
6.8.2.5 Printing the list of colorimetric sensors
Dialog window: Configuration ▶ Colorimetric sensors ▶ Edit ▶ &Print
(PDF)... ▶ Print list of colorimetric sensors (PDF)
With Edit ▶ &Print (PDF)..., the dialog window Print list of colorimet-
ric sensors (PDF) is opened.
Orientation
Selection of the printing orientation.
Selection Portrait | Landscape
Default value Portrait
Portrait
Output in portrait format.
Landscape
Output in landscape format.
[OK]
The sensor table is shown in the required format as a PDF file and can be
opened directly with Acrobat Reader; it can then be printed out and/or
saved.
6.8.3 Properties - Colorimetric sensor
6.8.3.1 Editing the sensor properties
Dialog window: Configuration ▶ Colorimetric sensors ▶ Edit ▶ Properties... ▶ Col-
orimetric sensor - %1
The Properties window for the colorimetric sensor selected in the Sensor
table in which the parameters of the colorimetric sensor can be edited is
opened with the menu item Edit
▶ Properties... in the subwindow Col-
orimetric sensors. It consists of the following tabs:
￭ Colorimetric sensor
General information regarding the colorimetric sensor, e.g. name,
device used and comment.
￭ Calibration data
Information about the calibration of the colorimetric sensor.