Metrohm tiamo 2.4 (process analysis) - Manual (Page 57)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
2 General program functions
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 41
Identifica-
tion Description Commands
.EME End measured value (measured
value after processing of the com-
mand) in the unit of the mea-
sured value DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec), CAL Cond,
CAL MEAS,
STDADD, DOS,
ELT MEAS
.ENP Electrode zero point for the sen-
sor used for the command
(dimensionless for pH sensor or in
mV for the ISE sensor) and/or
electrode zero point calculated
from the calibration (for STDADD
and CAL LOOP) DET pH, DET U,
MET pH, MET U,
SET pH, SET U,
STAT, MEAS pH,
MEAS U, MEAS
T, MEAS Conc,
STDADD, CAL
LOOP, DOS, ELT
LOOP
.EP{x}.CHA Charge for endpoint x (1 - 9) in
mA·s KFC, BRC
.EP{x}.DME Measured value differential for
the endpoint x (1 - 9) MET
.EP.DVT Drift for the endpoint x (1 - 9) in
µg/min KFC, BRC
.EP{x}.ERC ERC for the endpoint x (1 - 9) DET
.EP{x}.MEA Measured value for the endpoint
x (1 - 9) in the unit of the mea-
sured value DET, MET, SET,
KFT, KFC, BRC
.EP{x}.MEP Number of endpoints in the win-
dow x (1 - 9); 1 = 1 endpoint, 2
= 2 or more endpoints, 3 = EP
corrected with Autodrift, 4 =
EP corrected with manual
drift DET, MET, SET,
KFT
.EP.QTY Measured value for the endpoint
in µg KFC, BRC
.EP{x}.TEM Temperature for the endpoint x (1
- 9) in °C DET, MET, SET,
KFT, KFC, BRC