Metrohm tiamo 2.4 (process analysis) User Manual
Page 1315
■■■■■■■■■■■■■■■■■■■■■■
5 Method
tiamo 2.4 (for Process Analysis)
■■■■■■■■
1299
Set default value
Sets the digital input back to the set value in the configuration.
Start delay
Waiting time in seconds or minutes before the initiated action is started.
Input range
0 - 999999
Default value
0
Selection
s | min
Default value
s
Working time
The time for which the digital output can be set to ACTIVATED can be
specified in seconds or minutes when Action = Timer. It is reset to
DEACTIVATED after the working time has expired.
Input range
0.01 - 999999
Default value
0
Selection
s | min
Default value
s
End delay
Waiting time after the working time has expired
Input range
0 - 999999
Default value
0
Selection
s | min
Default value
s
Parameters
Parameter 1
The meaning of Parameter 1 depends on the Type of the digital output
that has been set.
When Type = Stirrer: stirrer output in %, pulse duration dependent on
Parameter 2.
Input range
-214783647 - 214783647
Default value
100
Parameter 2
The meaning of Parameter 2 depends on the Type of the digital output
that has been set.
For Type = Stirrer:
■
0: Duration of the switch-on pulse fixed at 500 ms.