Metrohm tiamo 2.4 (process analysis) - Manual (Page 1240)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1224 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the
device type belonging to the selected device is displayed instead.
If the option not defined is selected as Device name, any device types
or device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection Device types | 814 USB Sample Processor
Default value 814 USB Sample Processor
Target
Tower
Selection of the tower of the Sample Processor for moving to the required
lift position. Both Tower 1 and Tower 2 can always be selected even if the
Sample Processor has only one tower.
Selection 1 | 2
Default value 1
Lift position
Entering the desired lift position in mm or selecting a lift position prede-
fined for the rack Work position, Shift position, Rinse position or
Special position. A lift height of 0 mm corresponds to the Home posi-
tion. Here the lift is moved to the uppermost stop.
730, 778, 789, 814, 815, 855, 864
Input range
0 - 235 mm
Selection Work position | Shift position | Rinse position |
Special position | Home position
Default value Work position
774
Input range
0 - 100 mm
Selection Work position | Shift position | Rinse position |
Special position | Home position
Default value Work position
874
Input range
0 - 110 mm
Selection Work position | Shift position | Rinse position |
Special position | Home position
Default value Work position