Metrohm tiamo 2.4 (process analysis) - Manual (Page 776)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
760 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
Input range 1.0 - 2000.0 mV/mL
Default value 25.0 mV/mL
5.6.3.4.5.9 SET Ipol - Additional measured values
Tab: Method ▶ SET Ipol ▶ Properties... ▶ Additional measured values
Command name
Name of the command.
Entry 25 characters
A maximum of 6 additional measured values can be defined on this tab.
These values can then be saved together in additional measured value col-
umns with the measured values present in the default settings.
Additional calculated measured values
Additional calculated measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can
be calculated from existing measured values and saved, which can also be
presented as curves under the designation Calculated 1…3 and used in
formulas as variables 'Command name.CA1…3'.
[New]
Opens the Calc. measured value # dialog window, in which the param-
eters for the additional measured value can be entered (see Chapter
5.6.3.11.1, page 933).
[Properties]
Opens the Calc. measured value # dialog window, in which the param-
eters for the additional measured value can be edited (see Chapter
5.6.3.11.1, page 933).
[Delete]
Deletes the calculated measured value selected in the table.
Additional external measured values
Additional external measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can
be taken over and saved from existing measuring commands (i.e. MEAS)
which can also be displayed in curves under the designation Extern 1…3
and used in formulas as variables 'Command name.EX1…3'-