Metrohm tiamo 2.4 (process analysis) - Manual (Page 1304)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1288 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
The LOOP command is at the end of the loop for Repeat loops. As soon
as one stop condition is fulfilled (case 2), the command after the LOOP
command is carried out. If no stop condition is fulfilled (case 1), the loop
is run through again. In either case, the loop is run through at least once.
The LOOP command is at the beginning of the loop for While loops. If
the arrow has been dragged to a command after the LOOP command,
another arrow is automatically set from the previous command back to
the LOOP command. As soon as one stop condition is fulfilled (case 2),
the command after the loop is carried out. If no stop condition is fulfilled,