Metrohm tiamo 2.4 (process analysis) - Manual (Page 1075)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 1059
Command variables
The following command variables are generated by the MEAS Opt Conc
command in the method run and can be used in formulas under the des-
ignation 'Command name.Variable identification':
Identifica-
tion Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
.DBL Total duration for the processing of the command in s
.EME End measured value (measured value after processing of
the command) in the unit of the measured value
.ETE 1) End temperature (temperature after the command has
been processed) in °C
.FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command
has never ended
.IME Initial measured value (measured value before start con-
ditions are processed) in the unit of the measured value
.ITE 1) Initial temperature (temperature before start conditions
are processed) in °C
.LP.CAx Calculated value x (1 - 3) for the last measuring point on
the measuring point list
.LP.EXx External value x (1 - 3) for the last measuring point on
the measuring point list
.LP.CNT Intensity of the last measuring point in the measuring
point list in counts
.LP.MEA Measured value for the last measuring point in the mea-
suring point list in the unit of the measured value
.LP.TIM Time in s until the last measuring point in the measuring
point list is reached
.LP.TRN Transmission of the last measuring point in the measur-
ing point list in %
.MTE Temperature measurement with sensor; 1 = on, 0 =
off)
.NMP Number of measuring points in measuring point list