Metrohm tiamo 2.4 (process analysis) - Manual (Page 147)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Workplace
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 131
￭ Single determination - Controls
Buttons for starting, stopping, interrupting and resuming determina-
tions.
￭ Single determination - Status display
Shows the current status of the workplace.
￭ Single determination - Determination parameters
Entry of general parameters for the determination.
￭ Single determination - Sample data
Entry of method and sample identification for the next determination.
￭ Properties - Overview
Definition of the properties for the Single determination tab.
3.6.3.2 Single determination - Controls
Tab: Workplace ▶ Run ▶ Single determination
The following controls are located on the Single determination tab:
Starting a single determination (shortcut: Ctrl G)
The button is present in the status READY (no determination started),
COND READY (condition requirement fulfilled) and COND BUSY (condi-
tioning is running). If the start can be triggered, then it will be green, oth-
erwise light gray. Conditioning will be started first for methods that have
conditioning.
Stopping a single determination (shortcut: Ctrl S)
The button is present in the status BUSY (determination is running),
COND READY (condition requirement fulfilled) and COND BUSY (condi-
tioning is running), i.e. when conditioning has been started.
Interrupt run
The button is enabled (dark gray) in the status BUSY (determination is
running), COND READY (condition requirement fulfilled) and COND
BUSY (conditioning is running). The button is disabled (light gray) in all
other cases. When [Hold] is pressed, it will be replaced in the display by
[Cont].
Continue run