Metrohm tiamo 2.4 (process analysis) - Manual (Page 1659)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 1643
Only editable for controlled variable = calculated value, otherwise
grayed out and not available for editing.
Input range -214,783,647.000 - 214,783,647.000
Default value 0 or controlled variable setting, respectively
100% Mapping
Measured value to be used when the High level (100%) is applied as
input value.
Only editable for controlled variable = calculated value, otherwise
grayed out and not available for editing.
Input range -214,783,647.000 - 214,783,647.000
Default value 100 or controlled variable setting, respec-
tively
Unit
Unit of the measured value to be used.
Only editable for controlled variable = calculated value, otherwise
grayed out and not available for editing.
Entry 50 characters
Default value % or controlled variable unit, respectively
Default value
Selection or input of the default value which is to be used for the input if
the result is invalid.
Input range 0% mapping of the input - 100% mapping of
the input
Selection last value | Setpoint value
Default value last value
Setpoint value
Setpoint value to which the control is to be set.
Input range 0% mapping of the input - 100% mapping of
the input 'Mapping unit of the input or of the
calculated value'
Default value 0% mapping of the input 'Mapping unit of
the input or of the calculated value'
Control value
Selection of the control value from all of the analog outputs of the Con-
troller output type.
Selection 'Port designation'