Metrohm tiamo 2.4 (process analysis) - Manual (Page 20)

1.4 Method editor
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
1.4 Method editor
Introduction
The new graphic method editor gets more out of your titration system.
With the aid of the numerous templates, methods can be created quickly
and easily. For most routine and automated tasks, there are tried-and-
tested methods available. Just a few clicks and they are adapted and ready
to use.
One new feature is that actions running in parallel at the same time
can now be programmed and linked. Together with the new Titrando sys-
tem and the Robotic Sample Processors, a sample can be prepared while
the previous one is being titrated. This saves time and increases the sam-
ple throughput. The crowning feature is the simultaneous processing of
several samples. This means that one Titrando can carry out two titrations
at the same time. As a result, sample throughput is doubled!
tiamo is flexible and accommodates itself to analysis procedures, and not
the other way around.
Overview of functions
￭ Graphical method editor (see Chapter 5.6.1.2, page 438)
￭ Method manager (see Chapter 5.3.1, page 417)
￭ Separate management of access permissions for each method group
(see Chapter 5.4.2.3, page 429)
￭ Templates for method development and calculations (see Chapter
5.2.1, page 404)
￭ Plausibility check for methods (see Chapter 5.2.5, page 413)
￭ Comments can be added to the methods (see Chapter 5.2.4.2.9, page
412)
￭ Parallel runs (see Chapter 5.6.10.3.1, page 1285)
￭ Loop functions (see Chapter 5.6.10.4.1, page 1287)