Metrohm tiamo 2.4 (process analysis) - Manual (Page 1648)

7.20 IO controller
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1632 ￭￭￭￭￭￭￭￭
tiamo 2.4 (for Process Analysis)
Port description
Freely selectable designation for an analog output port. This designation is
used in the program to actuate the port.
Entry 50 characters
Default value AnOut_x_y_z
The following characters must not be part of the
port description: \ , ', ., {, }, [, ].
Port specification
Shows the specifications of the port.
Type
Display of the port type.
Low level (0%)
Display of the lowest analog output value.
This value is read out automatically and depends on the Type.
High level (100%)
Display of the highest analog output value.
This value is read out automatically and depends on the Type.
Unit
Display of the unit of the analog output value.
This value is read out automatically and depends on the Type.
NOTE
With the aid of the following parameters the physical values that are
applied to the analog output can be mapped to any measured value.
The transfer function is linear.
0% Mapping
Input range -214783648.000 - 214783647.000
Default value 0
100% Mapping
Input range -214783648.000 - 214783647.000
Default value 100