Metrohm tiamo 2.4 (process analysis) - Manual (Page 67)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
2 General program functions
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 51
Identifica-
tion Description Commands
.STY Type of stop with which the com-
mand was stopped: 1 = normal;
0 = manual or after error DET, MET, SET,
KFT, STAT,
MEAS, CAL
Cond, CAL
MEAS, CAL Spec,
STDADD, DOS,
ELT MEAS
.SVA Start volume absolute (volume
that was added according to the
start condition "start volume") in
mL DET, MET, SET,
KFT, STAT
.SVM Start volume measured value (vol-
ume that was added according to
the start condition "start mea-
sured value") in mL DET, MET
.SVS Start volume slope (volume that
was added according to the start
condition "start slope") in mL DET, MET
.SVT Total start volume (volume that
was added according to all three
start conditions) in mL DET, MET, SET,
KFT, STAT
.TC.TC Temperature coefficient of the
conductivity in %/°C MET Cond, MEAS
Cond, CAL Cond
.TC.C0 Coefficient of the Chebyshev pol-
ynomial of the conductivity of the
zero order MET Cond, MEAS
Cond, MEAS TC
Cond
.TC.C1 Coefficient of the Chebyshev pol-
ynomial of conductivity of the
first order MET Cond, MEAS
Cond, MEAS TC
Cond
.TC.C2 Coefficient of the Chebyshev pol-
ynomial of conductivity of the
second order MET Cond, MEAS
Cond, MEAS TC
Cond
.TC.C3 Coefficient of the Chebyshev pol-
ynomial of conductivity of the
third order MET Cond, MEAS
Cond, MEAS TC
Cond
.TC.C4 Coefficient of the Chebyshev pol-
ynomial of conductivity of the
fourth order MET Cond, MEAS
Cond, MEAS TC
Cond