Metrohm tiamo 2.4 (process analysis) - Manual (Page 845)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4 (for Process Analysis)
￭￭￭￭￭￭￭￭ 829
Command variables
The following command variables are generated in the method run by the
command KFC and can be used in formulas under the designation 'Com-
mand name.Variable designation':
Designation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
.CBY Command status; 1 = Conditioning activated, 0 =
Conditioning deactivated
.COK Command status; 1 = Condition requirement ful-
filled, 0 = Condition requirement not fulfilled
.DBL Total duration for the processing of the command in s
.DRI Current and/or last drift for drift correction in µL/min
.DTI Time for drift correction (time from the start of the
titration to the end of the command) in s
.EME End measured value (measured value after processing
of the command) in the unit of the measured value
.EP.CHA Charge for endpoint in mA·s
.EP.DVT Drift for the endpoint in µg/min
.EP.MEA Measured value for the endpoint in mV
.EP.QTY Measured value (water) for the endpoint in µg
.EP.TEM Temperature for the endpoint 1 in °C
.EP.TIM Time in s until the endpoint is reached
.EP.TIM Time in s until the endpoint is reached
.ETE End temperature (temperature following processing of
the command) in °C
.FIN Command status; 1 = Command has ended at
least once, 0, invalid (variable not available) = Com-
mand has never ended
.FP{x}.CHA Charge for the fixed endpoint × (1…9) in mA·s
.FP{x}.DVT Drift for the fixed endpoint × (1…9) in µg/min
.FP{x}.MEA Measured value for the fixed endpoint × (1…9) in the
unit of the measured value