Leica Geosystems Leica mojoXact Plus - Manual (Page 114)

114 System Information and Errors, Leica mojoXact Plus
9 System Information and Errors
Overview This chapter details how to access information about:
• the current status of the system, including the GPS satellites, GLONASS satellites,
inertials, corrections, cell modem signal strength, and the attached devices, such
as, the CAN Bus and the steering kit.
• the position of the system, including latitude and longitude, GPS and GLONASS
satellites used, RTK and GL1DE
TM
fix quality, RTK and GL1DE
TM
position count,
reference latency, heading, roll and pitch.
• serial numbers, software versions, internal and USB storage space, voltage and
temperature.
• the cell modem, including type, signal strength, network mode, serial number and
SIM card status.
• the errors that are active and recommended actions to correct them.
How to access system information and errors for a mojoXact Plus that is used with a
third-party terminal, is discussed in the sections below. For information on accessing
system information and details of errors when the mojoXact Plus is used with a Leica
mojo3D, refer to the Leica mojo3D User Manual.
9.1 Status Information
Overview The Status Information screen (shown below) provides the following data so the
operator can check the status of the system:
GPS - The number of GPS satellites being used by the mojoXact Plus
to create a position for GL1DE
TM
or Network RTK.
GLONASS - The number of GLONASS satellites being used by the
mojoXact Plus to create a position for GL1DE
TM
or Network
RTK.