Leica Geosystems Leica mojoXact Plus - Manual (Page 132)

132 Software Maintenance, Leica mojoXact Plus
11.3 Backing Up Current Software
General informa-
tion Once you have installed new software by downloading it from Virtual Wrench™, you
can backup the new software onto a USB memory key. This is useful in speeding up
the process when upgrading other mojoXact Plus units.

Refer to "Appendix B Formatting USB Memory Keys" for important informa-
tion about using USB memory keys with the mojoXact Plus products.
ƽ
CAUTION Do not turn the mojoXact Plus off, or remove the USB memory key, while the soft-
ware back up is in progress.
Backing up current
software, step-by-
step To back up the current software installed on your mojoXact Plus to a USB memory
key, carry out the following steps:
1. The USB interface is at the front of the
mojoXact Plus. Unscrew the door at
the front so it can open and lie flat, and
insert a compatible USB memory key
into the USB slot.
2. On the main navigation screen, select the Settings button.
The Settings menu appears.
3. Select the Software Settings button.
The Software Settings menu appears.
4. Select the Backup Software to USB button.
The Backup Software to USB screen appears.
5. To proceed with the backup of the software, select .