Leica Geosystems Leica mojoXact Plus - Manual (Page 16)

16 System Installation, Leica mojoXact Plus
2.5 mojoXact Plus Installation
Before installation Before installing the Leica mojoXact Plus, it is recommended that you do the
following steps. For more information on each of these important steps, please refer
to the installation hints specific to your vehicle and Leica Steer Ready Kit.
1. Refer to any available installation hints specific to your vehicle type.
This information may be available from the website, www.virtualwrench.com, or
may have been supplied with your system. The method of completion of the
following tasks is determined by the make and model of your vehicle.
2. Check or prepare for the mojoXact Plus power connection.
If you are connecting a mojoXact Plus with a Leica mojo3D, check that you have
a mojoXact port expansion cable and a mojo3D port expansion cable.
If you are connecting a mojoXact Plus with a third party terminal, check that you
have a mojoXact port expansion cable and a power cable.
3. Install steering cable (CAN bus).
There are many possible combinations for this step, depending on vehicle type,
or the Leica Steer Ready Kit used, or both. The cable specific to your vehicle
should be purchased with your system.

NOTE: If you are upgrading from a mojoXact to a mojoXact Plus, verify the CAN port
that the Steer Kit must connect to, as this may have changed. Section "2.6 CAN Port
Connection Changes" provides information on the CAN port changes.
mojoXact Plus
installation The mojoXact Plus can be mounted in any direction and there is no need to mount it
exactly flat. The mojoXact Plus should be mounted in a location so that:
• it does not obstruct the operation of the vehicle (such as the pedals).
• its front (where the USB port is accessed) is accessible.
• its rear is accessible to plug in and unplug cables.
To install the mojoXact Plus, carry out the following steps:
1. If the mojoXact Plus is still in its packaging, carefully remove it.
2. Using four screws and nuts, bolt the mojoXact Plus to a secure location.
3. Check that the mojoXact Plus is secure and cannot move.
If movement is possible then performance may be degraded.