Leica Geosystems Leica mojoXact Plus - Manual (Page 34)

34 Running the mojoXact Plus for the First Time, Leica mojoXact Plus
6. Enter the supplied password in the Password field.
7. To accept the values and move to the third screen for Cell Modem setup, select
.
To cancel any changes to the values and return to the previous Modem Settings
screen, select .
The third Modem Settings screen allows the operator to configure the Cell Network
Mode and SIM Card PIN.
8. The cell network mode defaults to Automatic. If this is not the correct setting for
your situation, select the correct value from the Cell Network Mode list.
9. If you have been assigned a personal identification number (PIN) for the
subscriber identity module (SIM) of the cell modem, enable the Use SIM Card PIN
checkbox.
10. Enter the PIN in the SIM Card PIN field.

If you make an error when entering the SIM PIN, it will be necessary to
remove the SIM card and reset it by entering a Personal Unblocking Code
(PUK), which you can obtain from your network provider.
11. To accept the values and return to the main navigation screen, select .
To cancel any changes to the values and return to the second Modem Settings
screen, select .
The Cell Modem icon displays in the information area at the bottom of the main
navigation screen. indicates a successful connection with good signal
strength, indicates that the connection is successful but the signal strength
is poor and indicates that the connection was not successful.