Leica Geosystems Leica mojoXact Plus - Manual (Page 76)

76 Correction Sources, Leica mojoXact Plus
If satellites are in use, but a GL1DE
TM
fix has not been obtained, it may be necessary
to wait a few minutes after the GPS connection is achieved, for the GL1DE
TM
fix to
occur. If this does not happen, restart the mojoXact Plus.

Note that when using GLI1DE
TM
fallback, the position will no longer be accurate. If
repeatability is needed then fallback should not be enabled.
Configuring
GL1DE
TM
as a fall-
back, step-by-step
If Network RTK, Internal Radio or External Radio is configured as the correction
source for a mojoXact Plus system, then the operator has the option to configure
GL1DE
TM
as the fallback position type should the other one fail.
To configure GL1DE
TM
as the fallback correction source, carry out the following steps:
1. At the main navigation screen, select the Settings button.
The Settings menu appears.
2. Select the Correction Settings button.
The Correction Settings menu appears.
3. Configure Internal Radio, External Radio or Network RTK. The last screen of their
configuration is the GL1DE
TM
Fallback screen.
4. To enable GL1DE
TM
Fallback select the Enable Fallback checkbox.
• Time Limit is the time in minutes that the system will use the GL1DE
TM
correc-
tion source. If the originally configured correction source has not come back
online in this time period, then auto-steer is disabled.
• Drift Limit - if the originally configured correction source comes back online
and the drift from the wayline is less than this value (in the units of the config-
ured region) then auto-steer remains enabled. However, if the drift from the
wayline is greater than this value, then auto-steer is disabled.
5. Adjust the values for Time Limit and Drift Limit, as applicable for your system.
6. To return to the main navigation screen, select .
To leave the values unchanged, and return to the previous screen, select .