Leica Geosystems Leica mojoXact Plus - Manual (Page 23)

Leica mojoXact Plus, Running the mojoXact Plus for the First Time 23
1. On the Region Settings screen, select the region (or country) from the Region
list.
2. Select the units to use for length from the Length list. Lengths may be measured
in Metric, Imperial, or US Standard units.
3. Select the units to use for speed from the Speed list. Speeds may be measured
in Metric, Imperial, or US Standard units.
4. Select the units to use for area from the Area list. Areas may be measured in
Metric, Imperial, or US Standard units. The Imperial acre is the defined interna-
tional acre, and the US acre is the slightly smaller US Survey acre.
5. To accept the Region settings and proceed through the setup wizard to the
Vehicle Type screen, select .
Vehicle setup,
step-by-step To setup the vehicle, carry out the following steps:
1. On the Vehicle Type screen (shown below), select your Vehicle Type from the
list.
2. In the Antenna Offset field, enter the value in the units appropriate for the
configured region, for how far the antenna is mounted from the center of the
wheel tracks, or vehicle’s cab (providing the cab is centered over the wheel
tracks), as indicated by the graphic. Ideally this value should be zero as the
antenna should be mounted in the center of the vehicle’s cab towards the front.
If the antenna is mounted to the right of the center of the vehicle (when facing
the forward direction of travel), enter the Antenna Offset as a positive value. If
the antenna is mounted to the left of the center of the vehicle, enter the
Antenna Offset as a negative value.
3. To accept the values and proceed through the setup wizard to the Vehicle
Settings screen, select .
To cancel any change to the value and return to the Region Settings screen,
select .