Leica Geosystems Leica mojoXact Plus - Manual (Page 18)

18 System Installation, Leica mojoXact Plus
Connecting the
mojoXact Plus to
the mojo3D To connect the mojoXact Plus to a Leica mojo3D, refer to the picture below and carry
out the following steps. For more detailed information, refer to the Leica mojo3D
User Manual. The following process assumes that the mojo3D has been installed in
accordance with the instructions in the Leica mojo3D User Manual.
1. If not already connected, connect the cell modem antenna cable (purple plug) to
the purple antenna socket on the back of the mojo3D.
2. Connect the GPS antenna cables (green and red plugs) to the green and red
antenna sockets on the mojoXact Plus.
3. Connect the mojo3D port expansion cable to the mojo3D.
4. Connect the mojoXact port expansion cable to the mojoXact Plus.
5. Connect the green cable of the mojo3D port expansion cable to the green cable
of the mojoXact port expansion cable.
6. Connect the power cable to the mojo3D and wire it to a reliable power source as
instructed in the Leica mojo3D User Manual.
7. Connect the steering controller to either the proprietary BUS for steering (yellow
CAN port of the mojoXact port expansion cable) or the ISOBUS (red CAN port of
the mojoXact port expansion cable) according to the table below in Section "2.6
CAN Port Connection Changes".
8. Ensure that any other required cables are connected correctly.
9. Route and secure all cables and wiring to ensure that there is no chafing or
rubbing, that could cause premature failure.
a) Cell modem antenna
b) mojo3D
c)
Power cable
d) Proprietary BUS for steering
e) ISOBUS
f) mojo3D port expansion cable
g) mojoXact port expansion cable
h) mojoXact Plus
i)
GPS antenna
a
b
c
d
i
f
g
h
e