Leica Geosystems Leica mojoXact Plus - Manual (Page 29)

Leica mojoXact Plus, Running the mojoXact Plus for the First Time 29
3.4 Main Navigation Screen
Once the Initial Setup Wizard is complete the main navigation screen is displayed. The
main navigation screen is the screen that the operator will view most of the time
during normal operation.
The main navigation screen has four main parts: the lightbar, main display, informa-
tion area and menu bar.
1. Lightbar
The lightbar is located at the top of the screen. It is a Leica Geosystems Smart
lightbar which uses both crosstrack error and heading error to guide the operator
to the line.
2. Main Display
The main part of the screen shows AB lines in perspective and highlights the line
that is engaged (or cannot be engaged). Horizontal dotted lines are used to show
movement when on the lines. Brief descriptions of current errors appear at the
bottom of this part of the screen.
3. Information Area
The information area is located at the bottom of the screen. Centered at the top
of this area is the row number that is currently engaged or that can be engaged.
Below this are icons that represent the current connection statuses of:
• The Correction Source in use (Network RTK, Internal Radio, External Radio or
GL1DE
TM
). Refer to Chapter "6 Correction Sources" for details on setting up a
correction source and diagnosing connection errors.
• The GPS connection.
• The cell modem signal. Refer to Section "3.6.2 Cell Modem Settings" for details
on setting up the cell modem and diagnosing connection errors.
• Virtual Wrench. Refer to Chapter "10 Virtual Wrench Remote Service" for
details on connecting to Virtual Wrench and diagnosing connection errors.
4. Menu Bar
The menu bar is located on the right side of the screen and provides buttons for: