Leica Geosystems Leica mojoXact Plus - Manual (Page 125)

Leica mojoXact Plus, Virtual Wrench Remote Service 125
10.1 Connecting to Virtual Wrench
Connecting to
Virtual Wrench
TM
,
step-by-step
The mojoXact Plus’ cell modem must be configured and have a good connection, and
you must have an internet connection before you can connect to Virtual Wrench
TM
.
To connect to Virtual Wrench™, carry out the following steps:
1. On the main navigation screen, select the Service button.
The Service menu appears.
2. Select the Virtual Wrench button.
If you have an internet connection, the Virtual Wrench screen
(shown below) appears.
If the cell modem is not configured or you do not have an internet
connection, a screen similar to the one below, appears.
Select , and configure the cell modem and its SIM Card before
attempting to connect to Virtual Wrench
TM
again.