Leica Geosystems Leica mojoXact Plus - Manual (Page 21)

Leica mojoXact Plus, Running the mojoXact Plus for the First Time 21
Loading the unlock
code manually,
step-by-step To unlock the universal terminal features of the system, carry out the following steps:
1. Select the Unlock Code field and enter the unlock code taking care with capital
letters and numbers, as the code is case sensitive.
2. Select the button.
If the unlock code was entered correctly and is accepted by the system, the Initial
Setup Wizard starts and its screen appears (refer to Section "3.3 Initial Setup
Wizard").
If an error occurred and the code was not accepted by the system, the message
"Invalid Authentication Code" displays below the Unlock Code field. Re-enter the
unlock code taking care with capitalization and numbers.
Loading the unlock
code from a USB
memory key, step-
by-step If you received a USB memory key from your dealer with the unlock code on it, carry
out the following steps to load the unlock code onto your mojoXact Plus:
The mojoXact Plus must be powered down.
2. Power up the mojoXact Plus, by turning on the vehicle’s ignition.
When the mojoXact Plus powers up, it automatically detects the USB memory key
and loads the universal terminal unlock code. When this process is complete, the
Initial Setup Wizard starts and the its screen appears (refer to Section "3.3 Initial
Setup Wizard").
1. The USB interface is at the front of the
mojoXact Plus. Unscrew the door at
the front so it can open and lie flat, and
insert the USB memory key that has
the unlock code loaded onto it, into
the USB slot.