Leica Geosystems Leica mojoXact Plus User Manual
Page 81
Leica mojoXact Plus, Correction Sources
81
11. If GL1DE
TM
Fallback is being utilised, adjust the values for the Time Limit and Drift
Limit, as applicable for your system.
12. To complete the Network RTK configuration and begin using the system, select
. You are returned to the main navigation screen.
To make no changes to the GL1DE
TM
Fallback settings and return to the Correc-
tion Source Status screen, select
.
When the mojoXact Plus is using Network RTK, a network status icon displays
near the bottom of the main navigation screen on the left. If there is a good
connection, an icon similar to
displays. Less bars display if the connection
is weak. If a connection error occurs then
displays and to diagnose the
problem:
• Check that the Network RTK settings are correct (Host, Port, Username, Pass-
word and Stream).
• Check that the cell modem connection is established.
• If an external modem is being used, ensure that it has power, is connected and
has a signal - refer to the modem’s documentation.
• Check that you have an internet connection, as explained in the Limitations
section previously.
• Check that you have a GPS connection, as explained in Section "6.1 GL1DE".
On the GL1DE
TM
Fallback screen the operator can choose to have the system use
the GL1DE
TM
correction source in the event that the Network RTK correction
source fails, by selecting the Enable Fallback checkbox.
• Time Limit is the time in minutes that the system will use the GL1DE
TM
correc-
tion source. If the Network RTK correction source has not come back online in
this time period, then auto-steer is disabled.
• Drift Limit - if the Network RTK correction source comes back online and the
drift from the wayline is less than this value (in the units of the configured
region) then auto-steer remains enabled. However, if the drift from the
wayline is greater than this value, then auto-steer is disabled.
10. Select or deselect the Enable Fallback checkbox.