Leica Geosystems Leica mojoXact Plus - Manual (Page 12)

12 System Installation, Leica mojoXact Plus
2 System Installation
2.1 Before Installation
General installa-
tion information

The installer must read and study this user manual, including the safety
directions (refer to Chapter "13 Safety Directions"). The installer must be
able to use the system in accordance with this user manual. Leica Geosys-
tems recommends that installation of the mojoXact Plus equipment be
performed by a qualified technician, as installation does require making
electrical connections.
• The following instructions are to be used as a general guide during the installa-
tion of the Leica mojoXact Plus. For more specific instructions, please visit
www.virtualwrench.com to view additional platform information and recom-
mended vehicle settings.
• The system will not operate at peak performance if steering joints and linkage
assemblies are not within the manufacturer's specifications. Check for worn
steering components by turning the steering wheel. As the steering wheel is
turned, the wheels should begin to move. If results are unsatisfactory, please
consult your vehicle manufacturer’s maintenance manual.
• Install the system in a clean and dry workshop environment. Failure to do so may
result in electrical short-circuits or other product malfunctions. Any moisture on
the roof of the vehicle will also prevent the antenna mounting tape from
sticking properly.
• Route and secure all cables and wiring to ensure that they do not chafe or rub,
as this could cause premature failure.
• The average installation time will vary, but it should be approximately two to four
hours per vehicle, but is dependent on vehicle type.
mojoXact Plus
installation
process The main steps involved in installing a mojoXact Plus system are:
• Read the documentation.
• Install the GPS Antenna.
• Install the Cell Modem Antenna (if applicable).
• Install the SIM Card in the mojoXact Plus (if applicable).
• Install the mojoXact Plus.
• Connect all cables.
• Route and secure cables to ensure the work environment is safe and so there is
no chafing or rubbing.
These steps are explained in the sections below.