Leica Geosystems Leica mojoXact Plus - Manual (Page 15)

Leica mojoXact Plus, System Installation 15
2.3 Cell Modem Antenna and Bracket
A cell modem antenna and bracket is supplied as part of the mojoXact Plus kit.
mojoXact Plus with
a third party
terminal When using the mojoXact Plus with a third party terminal, the supplied cell modem
antenna needs to be mounted. A bracket is supplied to aid installation of the cell
modem antenna. Choose a location for the antenna where it will get good reception,
that is, away from obstructions, and where the cable can be neatly routed without
kinking or crushing it, to the mojoXact Plus.
mojoXact Plus with
a mojo3D When operating the mojoXact Plus with a Leica mojo3D, the cell modem antenna
must be connected to the mojo3D, not the mojoXact Plus. If the mojo3D’s original
cell modem antenna is not installed, install the mojoXact Plus’s cell modem antenna.
Choose a location for the antenna where it will get good reception, that is, away from
obstructions, and where the cable can be neatly routed without kinking or crushing
it, to the Leica mojo3D.
2.4 SIM Card Installation
When using the mojoXact Plus with a third party terminal, it is necessary to install the
SIM Card in the mojoXact Plus. The process for installing the SIM Card is detailed
below. If the mojoXact Plus is used with a Leica mojo3D, then the SIM Card is installed
in the mojo3D. Refer to the Leica mojo3D User Manual for installation instructions.
Installing the SIM
Card in the
mojoXact Plus To install the SIM Card in the mojoXact Plus, carry out the following steps:
1. Carefully remove the mojoXact Plus
from its packaging and place it on a
workbench.
2. The SIM Card slot is at the front of
the mojoXact Plus. Unscrew the door
at the front (as shown at 2 in the
picture to the right) so it can open
and lie flat.
3. Use a pointed instrument to press
the release mechanism (as shown at
3 in the picture to the right), to
release the SIM Card holder.
4. Slide out the SIM Card holder (as
shown at 4 in the picture to the
right).
5. Place the SIM Card in the SIM Card
holder, with the chip facing up.
Ensure that the SIM Card is securely
seated in the holder.
6. Insert the SIM Card holder back into
the SIM Card slot and push it in so it
is secure in the mojoXact Plus.
7. Fold up the door and screw it in
place.
2