Leica Geosystems Leica mojoXact Plus - Manual (Page 46)

46 Vehicles and Implements, Leica mojoXact Plus
4.3 Implement Setup
Overview Implement setup allows the operator to configure measurements for an implement
that may be attached to the vehicle. These measurements are typically the width of
the implement and its offset from the center of the vehicle’s wheel tracks.
Implement setup,
step-by-step To configure implement measurements, carry out the following steps:
5. If the implement is offset to one side of the vehicle, that is, it is not centered
behind the vehicle, select the Implement Offset checkbox.
The Implement Offset field appears.
12. To complete terrain compensation and return to the main navigation screen,
select .
To return to the Vehicle Settings menu, select .
1. On the main navigation screen, select the Settings button.
The Settings menu appears.
2. On the Settings menu, select the Vehicle Settings button.
The Vehicle Settings menu appears.
3. On the Vehicle Settings menu, select the Implement Settings
button.
The Implement Settings screen appears.
4. In the Implement Width field, enter the entire width of the implement (as shown
in the graphic).