Leica Geosystems Leica mojoXact Plus - Manual (Page 75)

Leica mojoXact Plus, Correction Sources 75
Configuring
GL1DE
TM
as the
only correction
source, step-by-
step
To configure GL1DE
TM
as the only correction source, carry out the following steps:
When the mojoXact Plus is using GL1DE
TM
, the GL1DE
TM
icon displays near the
bottom of the main navigation screen on the left. If there is a good connection, this
icon displays. If a connection error occurs then displays and the problem
needs to be investigated. A connection error occurs if a GL1DE
TM
fix has not been
obtained and/or no GPS data is being received. The Position Status screen (refer to
Section "9.2 Position Information") provides information on the number of satellites
in use and the GL1DE
TM
Fix Quality - a value of 2 indicates that a fix has been
achieved. If there are no satellites being tracked or used:
• Check the GPS antenna and cables for damage. If either is damaged it may be
necessary to have them replaced.
• Check that the GPS antenna is not obstructed and ensure that it has a clear view
of the sky.
• If there is still no GPS connection, restart the mojoXact Plus.
1. At the main navigation screen, select the Settings button.
The Settings menu appears.
2. Select the Correction Settings button.
The Correction Settings menu appears.
3. Select the GL1DE
TM
Only button.
The GL1DE
TM
Only screen appears.
4. To accept GL1DE
TM
as the correction source setting and return to the main navi-
gation screen, select .
OR
To make no change to the correction source settings and return to the main navi-
gation screen, select .