Leica Geosystems Leica mojoXact Plus - Manual (Page 52)

52 Auto-Steer, Leica mojoXact Plus
9. To proceed with the steer kit setup, select the button. What screen appears
next is dependent on the steer kit that is selected.
To go back to the previous screen, select the button.
If the Steer Configuration screen appears, the operator has the opportunity to
write the configuration to the steering controller. Caution must be exercised
before writing the configuration to the steering controller, to ensure that the
steering controller does not contain any configuration that is needed, as the send
configuration operation will overwrite any existing configuration in the steering
controller with factory default settings.
10. If the Steer Configuration screen appears, and you are certain that the steering
controller needs to have configuration written to it, select Configure in the list.
If you are unsure about writing configuration to the steering controller, or you
know that the steering controller is configured, select Skip in the list.
11. To proceed with the steer kit setup, select the button. A message appears
informing you of whether the configuration was successfully sent to the steering
controller. What screen appears next is dependent on the steer kit that is
selected.
To return to the Steering Kit Status screen, select the button.
If the Steer Kit Options screen appears, the options available on the Steer Kit
Options screen depend on the functionality supported by the selected steer kit.
Stationary Engage and Reverse Steering may be available. For information on the
Stationary Engage and Reverse Steering functionality, refer to Section "5.4.1
Stationary Engage and Reverse Steering".
12. To enable Stationary Engage, select the Stationary Engage checkbox.
13. To enable Reverse Steering, select the Reverse Steering checkbox. Note that if
Reverse Steering is enabled, then Stationary Engage is automatically enabled
because Reverse Steering requires Stationary Engage to be enabled. Conversely,
if Stationary Engage is disabled then Reverse Steering is automatically disabled.
14. Adjust the Stationary Engage Time Limit as necessary for your system.