Leica Geosystems Leica mojoXact Plus User Manual
Page 115
Leica mojoXact Plus, System Information and Errors
115
Displaying status
information, step-
by-step
To view the status of the mojoXact Plus, carry out the following steps:
Inertials -
A
indicates that the inertials and sensors are working
correctly and the terrain compensation is current. A
indi-
cates that there is a problem with the inertials and sensors
and investigation is required to determine if this is a physical
problem or a terrain compensation needs to be performed.
Refer to Section "4.2 Terrain Compensation" for information
about the terrain compensation feature.
Corrections -
A
indicates that a correction source for position data is
configured and working. A
indicates that there is a
problem with the correction source and this will need to be
investigated to resolve the issue. Refer to Chapter "6 Correc-
tion Sources" for information on correction sources.
Cell Modem Signal
Strength -
Indicates the strength of the signal for the cell modem. A
indicates that the cell modem is configured and has a signal. A
indicates that either the cell modem is not configured, or
else if it is configured and there is a problem with the setup or
the signal. Refer to Section "3.6.2 Cell Modem Settings" for
information on cell modem setup and troubleshooting.
Attached Devices -
This section provides the status of the CAN Bus and the
Steering Kit. A
indicates that the device is setup and
working correctly. A
indicates that the device is not
working correctly. This could be due to the device not being
setup, or a problem with its operation. Refer to Chapter "5.2
Steer Kit Selection and Setup" for information on setting up a
steer kit.
1. On the main navigation screen, select the Service button.
The Service menu appears.
2. Select the Status Information button.
The Status Information screen appears.
3. To return to the main navigation screen, select
.
To return to the Service menu, select
.