Leica Geosystems Leica mojoXact Plus - Manual (Page 116)

116 System Information and Errors, Leica mojoXact Plus
9.2 Position Information
Overview The Position Status screen (shown below) provides the following data so the oper-
ator can check the current position status of the system:
Position - The latitude and longitude (in decimal degrees) of the
mojoXact Plus, and the altitude (in the length units configured
for the region).
GPS - The number of GPS satellites being tracked by the
mojoXact Plus using the L1 and L2 channels, and the number
of GPS satellites being used by the mojoXact Plus to create a
position for GL1DE
TM
or Network RTK.
GLONASS - The number of GLONASS satellites being tracked by the
mojoXact Plus using the L1 and L2 channels, and the number
of GLONASS satellites being used by the mojoXact Plus to
create a position for GL1DE
TM
or Network RTK.
RTK Fix Quality - The RTK position fix quality status. A value of 0 means that no
reference data is being received; 2 means reference data is
being used; and 3 means there is an RTK fixed position.
GL1DE
TM
Fix Quality - The quality indicator of the GL1DE
TM
position. A value of 1
means there is a single point solution, and a value of 2 means
there is a GL1DE
TM
fixed position.
RTK Position Count - The number of packets of RTK GPS data that has been received
by the mojoXact Plus since it was turned on.
GL1DE
TM
Position
Count -
The number of packets of GL1DE
TM
GPS data that has been
received by the mojoXact Plus since it was turned on. This
number should always be increasing by 20 per second.
Reference Latency - The time in seconds since the last packet of usable reference
data has been received by the mojoXact Plus. The ideal range
is between 0.1 and 3.0 seconds. The reference latency is
displayed as 60.00s when using GL1DE
TM
or there is no refer-
ence data.