Leica Geosystems Leica mojoXact Plus - Manual (Page 38)

38 Vehicles and Implements, Leica mojoXact Plus
4 Vehicles and Implements
General informa-
tion If the vehicle setup was not completed correctly during the initial setup using the
Initial Setup Wizard, or the mojoXact Plus has been re-positioned in the vehicle or
moved to a different vehicle, it maybe necessary to adjust the vehicle and implement
settings, including:
• Vehicle type selection and measurements.
• Terrain compensation and mojoXact Plus orientation.
• Implement measurements.
How to setup vehicles and implements when the mojoXact Plus is used with a third-
party terminal is described in this chapter.
For information on how to set up vehicles and implements when the mojoXact Plus
is used with a Leica mojo3D, refer to the Leica mojo3D User Manual.
4.1 Vehicle Measurement Setup
Overview Vehicle measurement setup involves selecting the type of vehicle that the
mojoXact Plus is installed in and entering measurements for the:
• Antenna Offset - how far the antenna is mounted from the center of the
vehicle’s wheel tracks.
• Antenna Height - how far the antenna is mounted above ground-level.
• Antenna to Fixed Axle - how far the antenna is mounted from the vehicle’s fixed
axle.
Vehicle measure-
ment setup, step-
by-step To select the vehicle type and configure its measurements, carry out the following
steps:
1. On the main navigation screen, select the Settings button.
The Settings menu appears.
2. On the Settings menu, select the Vehicle Settings button.
The Vehicle Settings menu appears.