Leica Geosystems Leica mojoXact Plus - Manual (Page 88)

88 Correction Sources, Leica mojoXact Plus
6.5 Correction Source Status
Overview The Correction Source Status screen, shown below, provides information on the
status of the network or base station that is providing the correction data.
The following data is displayed for the Internal Radio correction source. For the
Network RTK and External Radio correction sources, just the first six (6) items are
displayed. No data is displayed for the GL1DE
TM
Only correction source.
• Base Position: The current latitude, longitude and altitude of the base station in
decimal degrees format.
• Sats Tracked: The number of satellites being tracked by the base station.
• Reference Latency: The time in seconds since the last packet of useable refer-
ence data has been received by the mojoXact Plus. The ideal range is between
0.1 and 3 seconds. The reference latency is displayed as 60.00s when using
GL1DE
TM
or there is no reference data.
• Receiving Data: A indicates that the mojoXact Plus is receiving data from the
base station and a indicates that it is not.
• Distance: The distance between the base station and the mojoXact Plus.
• Packets Passed: The number of good packets of reference data received by the
mojoXact Plus. This value should increase by one (1) every one or two seconds.
• SW Version: The current software version installed on the base station.
• Serial Number: The device and serial number of the base station.
• Low Battery: A indicates that there is currently a low battery warning
message on the base station, and a indicates that there is not.
• External Power: A indicates that the base station is using an external power
source, and a indicates that it is not.