BECKHOFF EtherCAT IP Core for Xilinx FPGAs v3.00k - Manual (Page 78)

IP Core Signals
III-66 Slave Controller – IP Core for Xilinx FPGAs
8.5.2 RMII Interface
Table 24 lists the signals used with RMII.
Table 24: PHY Interface RMII
Condition Name Direction Description
Selected
communication
interface Port0/Port1 =
RMII
CLK50 INPUT
50 MHz reference clock
signal from PLL (rising edge
synchronous with rising
edge of CLK100), also
connected to PHY
nRMII_LINK0 INPUT
0: 100 Mbit/s (Full
Duplex) link at port 0
1: no link at port 0
RMII_RX_DV0 INPUT
Carrier sense/receive data
valid port 0
RMII_RX_DATA0[1:0] INPUT Receive data port 0
RMII_RX_ERR0 INPUT Receive error port 0
RMII_TX_ENA0 OUTPUT Transmit enable port 0
RMII_TX_DATA0[1:0] OUTPUT Transmit data port 0
2 communication ports
and
selected
communication
interface Port1 = RMII
nRMII_LINK1 INPUT
0: 100 Mbit/s (Full
Duplex) link at port 1
1: no link at port 1
RMII_RX_DV1 INPUT
Carrier sense/receive data
valid port 1
RMII_RX_DATA1[1:0] INPUT Receive data port 1
RMII_RX_ERR1 INPUT Receive error port 1
RMII_TX_ENA1 OUTPUT Transmit enable port 1
RMII_TX_DATA1[1:0] OUTPUT Transmit data port 1