Det-Tronics S3 Graphics - Manual (Page 110)

EAGLE QUANTUM PREMIER CONFIG. 11-29 EAGLE QUANTUM PREMIER CONFIG.
Version 6.0
The “Arrange” button allows movement of the location of the nodes on the schematic representing the LON to match
the actual way the LON is wired in the field. This is an important step for ease of future LON troubleshooting.
To use the “Arrange” function, click on the “Arrange”
button and drag the nodes into their desired locations. To
move a node, click and drag it over the area between the
two nodes at the new location, then release the mouse
button. The node will then be moved to this location but
retain its original address.
When the physical and logical addresses have been
reconciled, select the “Normal” button to return to the
standard LON configuration screen.
Display Type
A “toggle button” that allows either the default Node Number to be displayed on the LON schematic, as shown
in the example below, or the device type.
When the “Display Type” button is selected, the LON
schematic will substitute the device type for the node
number, as shown below. When the device type is being
displayed, the button on the configuration bar will toggle to
say “Display Number”, and when selected shifts the LON
schematic display back to the default Node Number view.
CONFIGURATION BAR • DISPLAY TYPE CONFIGURATION BAR • ARRANGE