Det-Tronics S3 Graphics - Manual (Page 88)

EAGLE QUANTUM PREMIER CONFIG. 11-7 EAGLE QUANTUM PREMIER CONFIG.
Version 6.0
Discrete Points
Globals tied to “discrete” ON/OFF type events can be set to alarm when the event transitions either High (ON)
or Low (OFF) with the “Alarm Condition” radio button. They can also be disabled which removes them from
tracking but leaves the event configured in case it is desired to activate it later without the need for knowing the
configuration details.
Transition On
When the tracked event transitions from the off state to the on state the alarm
will be activated as configured.
Transition Off
When the tracked event transitions from the on state to the off state the alarm
will be activated as configured.
The event configuration consists of selecting where the event is to be tracked (Printer, Disk, Alarm Window),
whether it will automatically clear when the event returns to its normal condition, what colors will be used for the
events normal and active states, and whether a recorded sound will be triggered when the event occurs.
There is also an option to allow the event to “trigger a fault”.
COMMAND BAR • GLOBALS COMMAND BAR • GLOBALS