Det-Tronics S3 Graphics - Manual (Page 322)

13-97 EQP LOGIC EDITOR
Version 6.0
Item 321 - Serial Port 4 Baud Rate
Serial baud rate for serial port 3 is set with this variable. The allowed selections are listed below.
Item 322 - Serial Port 4 Parity
Serial port 3 parity is set with this variable. The default parity is “None”. Refer to the data type section of this
document for the parity data values.
Item 323 - Serial Port 4 Address
The address field is reserved for future use.
Item 324 - Master Controller
This item is set true when the controller controls the LON outputs, master mode. A controller in standby mode
(hot back-up) will clear this item.
Item 325 - RS485 Ground Fault
This item is used to signal a ground fault on the RS485 port on the communications option board.
Item 326 - Communication Option Board Fault
This item is used to signal a fault with the communications option board. This fault is true when the communications
option board is missing or the wrong board type is selected/installed.
Item 327 - Invalid Device Parameter
This item is used to signal that a device configuration is invalid. First used with the X3302 detector.
Item 328 - Diminished Detection
This item is used to signal that a detector has diminished detection ability. First used with the X3302 detector.
Item 329 - Detection Disabled
This item is used to indicate that a detectors ability to detect a fire is disabled. First used with the X3302
detector.
Item 330 - Start Calibration
This control item is used to initiate calibration of a device.
Item 331 - Abort Calibration
This control item is used to abort the calibration sequence.
Item 332 - Calibration Step
This item is used to indicate the calibration step. Each device type can define the meaning of each step.
DEVICE ITEM NUMBER DESCRIPTIONS DEVICE ITEM NUMBER DESCRIPTIONS
Baud Rate Codes
Code Speed
3 9600
4 19.2K
5 38.4K
6 57.6K
7 115.2K
8 230.4K