Det-Tronics S3 Graphics - Manual (Page 91)

11-10 EAGLE QUANTUM PREMIER CONFIG.
Version 6.0
EAGLE QUANTUM PREMIER CONFIG.
Since hundreds of monitored global points can be created, a “Search” button is provided to quickly locate a
specific point entering all or part of the text from the points tagname.
A “Check” button ensures that the monitored global is indexed to a valid tag in the controller. If the tag has been
deleted after the creation of the monitored global, an error will be generated.
A “Delete” button is used to remove one or more monitored globals from the database.
Point Display
Shows detailed information about a selected node including status and diagnostics, alarm history, calibration
history and trend, and if applicable the current analog value. To access a device point display, select the device
from the LON schematic by single clicking on it. It will highlight as shown below.
Select the “Point Display” button and the appropriate display will open.
Each device type has a point display that is specific to the information available for its type of field device. In the
following example, a Point IR Gas Detector (PIRECL) is selected.
Both configuration and dynamic information for
the device are arranged in a logical manner
and presented on a full screen template. If
the controller is not currently connected and
communicating with the S 3 station then no
“watchdog timeout” will be displayed for the
selected point. Simulated data is only displayed
if no hardware key is installed.
COMMAND BAR • POINT DISPLAY