Det-Tronics S3 Graphics - Manual (Page 323)

13-98 EQP LOGIC EDITOR
Version 6.0
Item 333 - Lon Overload Fault
This item is used to indicate that user logic is attempting to write more data to LON output devices then the LON
can accommodate.
Item 334 - User String Display Enable
When this configuration item is true the controller descriptor text (item 9) will be displayed on the controller
faceplate while in normal mode (scrolling marque).
Item 335 - Controller Display Mode
European approvals (EN54) and China approval bodies require specific information to be displayed by the
controller. Approval requirements also specify specific modes of operation which differ from Premier’s traditional
operation. This item is used to select the proper mode of operation. This list may grow over time to fulfill
requirements from different markets.
Controller Display Mode
Value Mode
1 Traditional
2 International
Item 336 - User Alarm
This item is only used internally by the AlarmTrigger logic function and is not associated with a particular
device.
Item 337 - First Stage Alarm
First alarm output from a X3301A Automotive detector.
Item 338 - Second Stage Alarm
Second alarm output from a X3301A Automotive detector.
Item 339 - Config Port Relay Control
This status item is used to control a relay that switches the configuration port serial line from a primary controller to
a secondary controller. The item goes true when the serial line should be connected to the secondary controller.
The serial line is normally directed to the master controller except during the configuration process. In user logic
this bit should be connected to one of the controller relays. The normally open contacts of the two relays (one
from each controller) should be paralleled together to drive an external relay that switches the Rx and Tx comm
lines.
Item 340 - Alarm Hold Timer
First used with the X3301A Automotive detector. Refer to the X3301 Automotive specification for details on this
parameter.
Item 341 - Stage 2 Delay Timer
First used with the X3301 Automotive detector. Refer to the X3301 Automotive specification for details on this
parameter.
Item 342 - Small Fire DelayTimer
First used with the X3301 Automotive detector. Refer to the X3301 Automotive specification for details on this
parameter.
DEVICE ITEM NUMBER DESCRIPTIONS