Det-Tronics S3 Graphics - Manual (Page 241)

13-16 EQP LOGIC EDITOR
Version 6.0
EQP LOGIC EDITOR
In the example below the MB address “00001” is configured to be moved to a Premier controller global variable
“MCOP-FA001” and MB address “00002” in the process of being “dropped” onto a Premier controller global
memory point “MCOP-FA002”.
The radio buttons on the left hand side of the dialog box will determine
which configured global variables are displayed.
In the example to the right the “Boolean” radio button is selected and the
three configured boolean globals are displayed as potential targets for
data input.
Note
Data coming from a Modbus system into the Premier controller can only
be moved into global memory locations that have been configured using
the Global Memory editor as described on preceding pages of this
manual.
The three available Modbus data tables are accessed by the three tabs at the top of the right hand side of the
dialog box. Select the table desired by clicking on the appropriate tab.
LOGIC EDITOR • CONTROLLER MENU