Det-Tronics S3 Graphics - Manual (Page 231)

13-6 EQP LOGIC EDITOR
Version 6.0
EQP LOGIC EDITOR
Show Line Marks
In the logic editor when a line is selected by clicking on it, or, when the “Connection Tool” has been selected, a
small black rectangle marks the beginning and end of each line as shown in the first example below.
Selecting “Show Line Marks” as in the example below, will display an additional three visual indicators spaced
between the beginning and end of the line to provide better visual cues on lines that are long or close to many
others.
This is only a visual cue and has no effect on the ability to select or edit the line.
Show Full Paths
A tagname might be a channel on an IDC or HDIO or
it could be the complete device. This option allows for
the complete path to be shown.
In the example to the left, an IDC which is tagged
IDC-010 has two channels. One channel is “MAC Fire”.
When “Show Full Paths” is enabled the channel tagname
is to be shown to the left of the tagname, as shown in
the example to the right. It now reads; “IDC-010.MAC
Fire”.
LOGIC EDITOR • EDIT MENU