Det-Tronics S3 Graphics - Manual (Page 317)

13-92 EQP LOGIC EDITOR
Version 6.0
Item 291 - Redundancy Fault Code
This item can be used to determine the cause of a Redundancy fault.
Code Description
0 No Fault
1 Alarm below threshold
2 No Comm From other controller
3 Parse Error
4 Ack Comm Error
5 Standby Fault
6 Program Flow Error
7 LON A Interface Fault
8 LON B Interface Fault
10 Application Memory Error
11 User Logic Error
12 Invalid Configuration
13 No Lon communication between controllers
14 Error in Response
Item 292 - Request Manual Switch
This control item is only used with a redundant controller configuration. When this bit is set in a Master controller
a switch to the standby controller is initiated. The switch will only occur if the standby controller is online and in
a health state.
Item 293 - Beeper Status
The status of the internal audible beeper is reflected with this variable.
Beeper Status
Value Description
0 Off
1
Beeper Test (Active during lamp
test)
2 Gas Alarm
3 Trouble
4 Supervisory
5 Fire
Item 294 - Communication Option Board Type
This configuration item determines what type of Communication Option Board is attached.
Communication Board Type
Value Description
0 None
1 Type A
DEVICE ITEM NUMBER DESCRIPTIONS