Det-Tronics S3 Graphics - Manual (Page 319)

13-94 EQP LOGIC EDITOR
Version 6.0
Item 298 - Control Mode
This item selects the embedded logic control mode.
Value Mode
0 Invalid
1 Embedded Logic Only
2 Controller Only
3 Back-up Mode
Embedded Logic Only: In this mode the device will always use the embedded logic and ignore control messages
from the controller.
Controller Only:
In this mode the device will accept control information from the controller and never use
embedded logic. If communication with the controller is lost the outputs shall retain their last state.
Back-up Mode:
In this mode the device will accept control information from the controller and only use embedded
logic when communication with the controller is lost.
Item 299 - Detection Circuit Delay
This item allows the selection of a delay time that will apply to detector circuits, as well as a manual release (30
second max. for manual release, this will be handled by the field device). Time delay selection range from 0 to
60 seconds in 10-second increments. This could also be called an abort timer; it gives the user an opportunity
to hold off a release during an investigation time.
Item 300 - Abort Active
This item is true while the release abort input is active. First used with the IPM (DCIO smoke) module.
Item 301 - Manual Release Active
This item is true while the Manual Release input is active. First used with the IPM (DCIO smoke) module.
Item 302 and 303 - Zone 1 and 2 Alarm
These items reflect the alarm status of smoke detector loops. First used with the IPM (DCIO smoke) module.
Item 304 - Signal Circuit Active
This item is true while the alarm signal circuit (SAM output) is active. First used with the IPM (DCIO smoke)
module.
Item 305 and 306 - Release Circuit 1 and 2 Active
These items reflect the state of the release outputs. First used with the IPM (DCIO smoke) module.
Item 307 - Manual Reset Required
This item comes true when the IPM requires a manual reset.
Item 308 - Embedded Abort Timer
This item holds the amount of time remaining in the embedded abort timer.
DEVICE ITEM NUMBER DESCRIPTIONS