Altera Video and Image Processing Suite - Manual (Page 128)

Parameter Value Description
Number of color planes in
parallel
1–3, Default = 1 Select the number of color planes in parallel.
Include Avalon-MM interface On or Off Turn on if you want to specify clipping offsets
using the Avalon-MM interface.
Clipping method
• Offsets
• Rectangle
Specify the clipping area as offsets from the
edge of the input area or as a fixed rectangle.
Left offset Positive integer,
Default = 10 Specify the x coordinate for the left edge of
the clipping rectangle. 0 is the left edge of the
input area.
Note: The left and right offset values
must be less than or equal to the
input image width.
Right offset Positive integer,
Default = 10 Specify the x coordinate for the right edge of
the clipping rectangle. 0 is the right edge of
the input area.
Note: The left and right offset values
must be less than or equal to the
input image width.
Width Positive integer,
Default = 10 Specify the width of the clipping rectangle.
Top offset Positive integer,
Default = 10 Specify the y coordinate for the top edge of
the clipping rectangle. 0 is the top edge of the
input area.
Note: The top and bottom offset values
must be less than or equal to the
input image height.
Bottom offset Positive integer,
Default = 10 Specify the y coordinate for the bottom edge
of the clipping rectangle. 0 is the bottom edge
of the input area.
Note: The top and bottom offset values
must be less than or equal to the
input image height.
Height Positive integer,
Default = 10 Specify the height of the clipping rectangle.
8-2 Video Clipping Parameter Settings
UG-VIPSUITE
2015.05.04
Altera Corporation Video Clipping IP Cores
Send Feedback