Altera Video and Image Processing Suite - Manual (Page 246)

}
}
Test Pattern Generator Parameter Settings
Table 19-2: Test Pattern Generator Parameter Settings
Parameter Value Description
Run-time control of image size On or Off Turn on to enable run-time control of the
image size. When turned on, the output size
parameters control the maximum values.
Maximum image width 32-2600, Default = 640 Specify the maximum width of output in
pixels.
Maximum image height 32-2600, Default = 480 Specify the maximum height of output in
pixels. This value must be the height of the
full progressive frame when producing
interlaced data.
Bits per pixel per color plane 4-20, Default = 8 Select the number of bits per pixel (per color
plane).
Color space RGB or YCbCr Select whether to use an RGB or YCbCr color
space.
Output format 4:4:4, 4:2:2, 4:2:0 Select the format/sampling rate format for the
output frames.
Color plane configuration Sequence, Parallel This function always produces three color
planes but you can select whether they are
transmitted in sequence or in parallel.
Interlacing
• Progressive output
• Interlaced output
(F0 first)
• Interlaced output
(F1 first)
Specify whether to produce a progressive or
an interlaced output stream.
Pattern
• Color bars
• Uniform
background
Select the pattern for the video stream output.
Uniform values 0-255, Default = 128 When pattern is uniform background, you
can specify the individual R'G'B' or Y' Cb' Cr'
values depending on the currently selected
color space.
19-4 Test Pattern Generator Parameter Settings
UG-VIPSUITE
2015.05.04
Altera Corporation Test Pattern Generator IP Cores
Send Feedback