Follett VERSION 6.00 - Manual (Page 701)

04/04 701 Appendix H Configuring scanners
Programming codes for ScanTeam 3400 CCD scanner
To program the ScanTeam 3400 CCD for ISBN scanning, scan the following seven
programming codes. Scan the barcodes in order from 1) through 7). Scan each
barcode only once. After scanning each barcode, you will hear 1 or 2 beeps,
indicating that the scan was successful.
1) 2 beeps 5) 1 beep
2) 1 beep 6) 1 beep
3) 1 beep 7) 2 beeps
4 ) 1 beep
ScanTeam 5400 Laser
Note: The programming sheet included in this section can only be used with the
ScanTeam 5400 Laser scanner (DOS/WIN/MAC) with certain software
revisions.
Getting ready
Before you start programming the ScanTeam 5400 Laser, you'll need to verify that
you have the correct scanner by doing the following:
1. Determine which scanner you have by viewing the label underneath the
scanner. Item numbers 722246 and 722245 are all item numbers associated
with a ScanTeam 5400 Laser Scanner.
2. Determine which software revision is installed in your scanner by viewing
the label underneath the scanner. If you have any of the following revisions,